Vicor 3623 ChiP DCM Evaluation Board

Author : Vicor Published Time : 2018-03-30
Vicor 3623 ChiP DCM Evaluation Board is designed for evaluating low input voltage 3623 ChiP DC-DC converters. Users can configure Vicor 3623 ChiP DCM Evaluation Board for various enabling and fault monitoring schemes. This eval board can also be configured to exercise various modes of trimming, depending on application requirements. This eval board can be used to evaluate DCMs in a stand-alone configuration or as an array of modules.

Features

Input and output lugs for source and load connectionsInput fuse (appropriately rated)Basic input filtering, including sockets to add through-hole input aluminum-electrolytic capacitors for additional source decouplingBasic output filtering, including sockets to add through-hole output aluminum-electrolytic capacitorsToggle switch for enabling and disabling the DCM via the ENABLE pinTrim control selection: using potentiometer, using external voltage source, open to disable trimming and latch the model nominal trim conditionProvisions to replace input and output differential mode inductors with wire loops, for oscilloscope/shunt based current measurementsOscilloscope probe jack for accurate, high frequency output voltage measurementsDual paralleling connectors for ENABLE, TRIM, FAULT, and SGND signal connections, for daisy chaining control to other DCM evaluation boards in an arrayKelvin voltage test points for all power pinsTop and bottom heatsink assembly for the DCM
Vicor Newest

Vicor DCM2322x Isolated & Regulated DC-DC Converters operate from an unregulated and wide-range input to generate an isolated Vdc output.

Date: 2019-09-12

Vicor PI358x-00 ZVS Switching Regulators are high input voltage, wide‑input‑range Buck regulators which integrate a controller and power switches within a high-density 37-pin GQFN package.

Date: 2019-05-17

Vicor PI358x-00 ZVS Buck Regulator Evaluation Boards is designed for the PI358x family of 7mm x 8mm ZVS Bucks.

Date: 2019-05-17

Vicor NBM2317 Bus Converter offers a continuous output power rating of 800W and a 38 to 60VDC high-side voltage range.

Date: 2019-02-25

Vicor VITA 62 Power Supplies are Commercial Off-the-Shelf (COTs) power supplies that are designed for 3U Open VPX systems.

Date: 2019-02-14

Vicor TPM1714 Three-Phase AC Input Front-End-Modules (FEMs) are designed to interface directly with worldwide three-phase AC mains and provide a rectified AC input.

Date: 2018-09-18

Vicor 3623 ChiP DCM Evaluation Board is designed for evaluating low input voltage 3623 ChiP DC-DC converters.

Date: 2018-03-30

Vicor DCM3623 Isolated, Regulated DC Converters, available at Mouser, are optimized for array operation with no power derating needed.

Date: 2018-02-19